Abstract 2172


Previous studies on clot formation have shown that the mechanical properties of clots have direct effects on hemostasis and thrombosis, and alterations of those clot mechanics are associated with disease(Collet, et al. 2006) (Hvas, et al. 2007). As such, understanding the mechanical properties of clots is vital to understand hemostasis and thrombosis. As platelets drive this contraction phenomenon, single platelet measurements are required to obtain a mechanistic understanding of the retraction process and to identify specific therapeutic targets for disease states in which platelet/clot retraction is pathologically altered. In addition, as fibrin has recently been shown to have extremely complex material and mechanical properties (Brown, et al. 2009), single platelet studies would decouple the effects of fibrin from platelets when examining clot mechanics. However, few studies have focused on the biomechanical role of platelets in clot formation and clot mechanics, especially at the single cell level. Our group has recently published measurements of single platelet contraction (Lam, et al, Nature Mat, 2011), showing that platelets are capable of applying large forces and are quite varied in their response. However, the key barrier which has prevented the study of single platelets has been the lack of a technology with the sufficient precision and sensitivity to both manipulate and measure individual platelets in a high throughput manner. To that end, we have extended a technique (Polio, et al. 2012) that is capable of measuring the contraction of individual platelets in a high throughput manner.


Here we precisely pattern FITC conjugated fibrinogen dots in a geometrical array (Fig 1A) on polyacrylamide (PAA) gels. Thrombin activated platelets are incubated on the gel and contract upon contact with the micropatterned fibrinogen “dots”. When the platelet comes into contact with two dots and contracts, the distance in which the platelet moves the dots from their original position is used to determine the force. Conceptually, this is similar to the idea of a linear spring, in which a certain spring displacement corresponds to a known force. Using this technique, we measured 71 platelets which were attached to two fibrinogen dots each, and found that on low stiffness gels, that the average contractile force was approximately 4nN (Fig 2A). Platelets may attach to a maximum of four dots, but do so with a much lower frequency as compared to two dots (Fig 2B). Preliminary results indicate that as platelet area increases, as indicated by contact with additional protein “dots”, the total force exerted by the platelet increases, with a maximum contractile force achieved when touching three protein dots (Fig 2C). Based on this data, there may be an optimum platelet spread area that maximizes contractile force.

Conclusions and Ongoing Efforts:

We will determine how the biophysical parameters, such as micro-environmental stiffness and shear flow, quantitatively affect platelet contractility. As our current understanding of the underlying biological mechanisms of platelet contraction is solely qualitative, we will also quantitatively investigate the biological signaling pathways of platelet contraction using pharmacological agents and platelet agonists using our system. Pharmacologic agents including glycoprotein IIb/IIIa (integrin αIIbβ3) antagonists, Rho kinase inhibitors, calcium inhibitors, and myosin inhibitors, will be used to measure the quantitative effect each biological component has on platelet contraction. In addition, soluble agonists known to activate platelets including thrombin, ADP, thromboxane A2, and epinephrine will be investigated quantitatively and systematically to measure their interactive and synergistic effects on platelet contraction. Furthermore, this device represents a new platform which could be used in drug discovery and to test for changes in platelet contraction with differing pharmacological doses.


No relevant conflicts of interest to declare.

Author notes


Asterisk with author names denotes non-ASH members.

Sign in via your Institution